How to assemble Geekroo GPIO Breakout kit for the Raspberry Pi Model B/A
Part List
How to use
Soldering
Firstly, you need to do some soldering. This step is pretty straightforward:
After soldering, it should be looking like this:
The other side:
Back to top
Plug into your breadboard
Now you can plug it into your breadboard:
Please make sure the 5V and 3.3V pins go into breadboard power lines properly:
And other pins as well:
Back to top
GPIO cable
Connect the breakout board to your Raspberry Pi with the 26-pin GPIO cable:
Back to top
Power up your breadboard
Put the jumper header on, turn on your Raspberry Pi, you can get 3.3V power to your breadboard:
As same as 5V:
